How to Apply

YOU NEED for a wet or dry installation:

• Assembly squeegee
• Fix-On assembly spray (for a wet assembly see assembly video below)
• Water with a drop of washing-up liquid & pump spray bottle (for a wet assembly see assembly video below)
• Alcohol or alcohol
• Ruler or tape measure
• Masking tape roll
• large scissors & cutter knife
• this work is best done in pairs

Instructions for wet gluing / assembly

"please prepare"

Fill the spray area with water and add 3 drops of dishwashing detergent (to 1 liter of water). This fluid will later serve as an assembly fluid.

If you have our Fix-On mounting fluid, please use it undiluted, with Fix-On mounting is much easier (see Fix-On item description)

1.PRESS

Roll out the sticker flat and rub the squeegee firmly over the front and back.

2. CLEAN

Thoroughly clean the surface / body (e.g. with alcohol or spirit). The surface to be glued must be dry, free of dust and grease, also clean around the door edges & inside as well as corners and edges.

3. Spray the surface

Spray the surface to be glued all over with Fix-On or with the water-detergent mixture.

4. Stickers

Carefully peel the sticker off the backing paper (this work is best done in pairs)

5. Affix and coat the sticker

If the surface to be glued is sprayed sufficiently, you can place the sticker together with the carrier film on the surface to be glued and slide it into the desired position. Now the water has to be spread with a squeegee. Squeegee from the center outwards until the sticker can no longer be moved.

Let the sticker dry and take care when working with the detergent mixture you should have a temperature between 13 ° C and up to 15 ° C.

If you mount with FIX-ON mounting liquid, the sticker can be mounted from 3 ° C (see Fix-On item description)

6. DONE

Carefully pull off the transfer film at a flat angle and you're done Tip: Pierce small air bubbles with a sewing needle and push the air out with your fingernail.

Attention: A visit to the car wash and the operation of the rear window wiper (for rear window stickers) should be avoided for at least 2 weeks.

7. Installation video wet gluing.

Instructions for a dry assembly

1.PRESS

Roll out the sticker flat and rub it firmly across the front and back with a squeegee (or credit card).

2. CLEAN

Thoroughly clean the surface (e.g. with glass cleaner). It must be free of dust and grease.

3. FIX

When positioning, orientate yourself on the motif - not on the transfer film. Then fix the sticker at the top with a strip of masking tape.

The strip serves as a "hinge" when glued on.

4. PREPARE

Fold the sticker up and carefully peel off the backing paper. Caution: The motif must adhere completely to the transfer film.

5. STICK ON

Put the sticker down again and hold it tightly a little above the surface. Now start from the top, pressing the motif from the center towards the edge.

6. DONE

Carefully pull off the transfer film at a flat angle - ready! Tip: Pierce small air bubbles with a sewing needle and push the air out with your fingernail.

Attention: A visit to the car wash and the operation of the rear window wiper (for rear window stickers) should be avoided for at least 2 weeks.

7. Installation video dry gluing.